Inspections & Testing

American Quality Roofing performs detailed, professional visual inspections with state-of-the-art moisture detection devices and gives thorough explanations with digital pictures. We promise this, hand delivered, in 24-48 hours. We also promises reasonable charges on inspections - $125 and up, based on roof size, condition, detail work and time required. The inspection fee is deductible from cost of requested repairs and reroofing.

AFFILLIATE QUALIFICATIONS (Engineer Testing)

Miami Dade County Building Code Compliance.
Certified Materials Testing Labratory.
Florida Registered Professional Engineer, R.N. Sailappan, P.E.

TAS 105 - Fastner Withdrawl Resistance Testing
TAS 106 - Uplift Resistance Testing Tile Roof
TAS 109 - Polyurethane Foam Roofing (pending certification).
TAS 124 - Existing and New Roof Wind Uplift Resistance Testing.
TAS 126 - Roof Moisture Survey - Nuclear/Infrared (pending certification)

(Click images to enlarge)

CERTIFICATIONS

M/WBE Certification, Dade County, Florida.
A.H.E.R.A. Building Inspector.
Roof Consultants Institute, Roof Consulting.
Troxler Laboratories, Nuclear Testing Equipment Safety.

Anyone who wants an engineer test should get Florida Roof testing information as Affiliate.

INSPECTION PROCEDURES

The starting point of the Inspection should be the interior of the building. The interior walls and ceilings should be checked for signs of water arid staining. After inspecting the interior a thorough inspection of the exterior walls should be made along with the roof system.

(Click to enlarge)

The following roof components should be inspected:

Flashing: These are the protection for the membrane termination and often provide a waterproof cover at the membrane termination. These include Counter- flashing, expansion joint covers, copings and flashing at walls and curbs. A variety of problems may occur at these vulnerable locations.

Penetrations: These are pipes, drains, vents, stacks and other items that penetrate the roof membrane. These MUST be flashed properly to assure a watertight roof system.

Field Membrane - What to look for:

· Open seams excessive blisters, wrinkles, ridges or areas of non-adhered membrane.
· Worn spots holes or deteriorated areas of the membrane.
· Deteriorated, areas of surface coating on the membrane.
· Adequate, drainage and ponding problems of the membrane.
· Areas around rooftop equipment that may have been degraded by leaks or spills or punctured by dropped equipment parts.

Leak Maintenance Procedure:

1. Protect the interior.
2. Remove excess water from the roof. Check roof drains and scupper boxes to be certain that they are functional. Excessive ponding on the roof may cause roof system damage, structural damage or even roof collapse.
3. Locate the source of the leak by locating the paint an the roof above the leak in the building's interior.
4. Perform necessary repairs. Once the source of a leak is located, the materials and procedure used to make the roof watertight will be determined by the roofing professional.